Statistical Optimization of Flavonoid and Antioxidant Recovery from Macerated Chinese and Malaysian Lotus Root (Nelumbo nucifera) Using Response Surface Methodology

In this study, the combination of parameters required for optimal extraction of anti-oxidative components from the Chinese lotus (CLR) and Malaysian lotus (MLR) roots were carefully investigated. Box–Behnken design was employed to optimize the pH (X₁: 2–3), extraction time (X₂: 0.5–1.5 h) and solvent-to-sample ratio (X₃: 20–40 mL/g) to obtain a high flavonoid yield with high % DPPH_sc free radical scavenging and Ferric-reducing power assay (FRAP). The analysis of variance clearly showed the significant contribution of quadratic model for all responses. The optimal conditions for both Chinese lotus (CLR) and Malaysian lotus (MLR) roots were obtained as: CLR: X₁ = 2.5; X₂ = 0.5 h; X₃ = 40 mL/g; MLR: X₁ = 2.4; X₂ = 0.5 h; X₃ = 40 mL/g. These optimum conditions gave (a) Total flavonoid content (TFC) of 0.599 mg PCE/g sample and 0.549 mg PCE/g sample, respectively; (b) % DPPH_sc of 48.36% and 29.11%, respectively; (c) FRAP value of 2.07 mM FeSO₄ and 1.89 mM FeSO₄, respectively. A close agreement between predicted and experimental values was found. The result obtained succinctly revealed that the Chinese lotus exhibited higher antioxidant and total flavonoid content when compared with the Malaysia lotus root at optimum extraction condition.     

Azobenzene‐Functionalized Cage Silsesquioxanes as Inorganic–Organic Hybrid,Photoresponsive, Nanoscale,Building Blocks

Mono‐ and octa‐azobenzene‐functionalized cage silsesquioxanes were easily synthesized by the reaction of 4‐bromoazobenzene with monovinyl‐substituted octasilsesquioxane and cubic octavinylsilsesquioxane through the Heck coupling reaction. Excited‐state energies obtained from time‐dependent density functional theory (TDDFT) and the CAM‐B3LYP functional correlate very well with experimental trans–cis photoisomerization results from UV/Vis spectroscopy. These azobenzene‐functionalized cages exhibit good thermal stability and are fluorescent with maximum emission at approximately 400 nm, making them potential materials for blue‐light emission.     

两个DEA的逆问题的解法的探讨

文[1]提出了两个DEA的逆问题，并用搜索法来解．而本文根据所证的定理，对每个问题一般只要解二、三个线性规划问题就能得到答案．     

Ⅱ-Ⅵ族化合物薄膜电致发光

电致发光薄膜是平板显示器的重要材料之一,我们从研究ZnS:Mn,Cu直流电致发光薄膜的大面积稳定发光开始,首次将稀土离子引进直流电致发光薄膜,实现了各色的直流电致发光,并研究其激发机理、过热电子的能量分布、稀土离子的碰撞截面和稀土离子发光中心在晶格中的位置等。在国内首先研制成功ZnS:Mn交流电致发光薄膜计算机终端显示器,并扩大面积到640×480像素(对角线10英寸)。为了实现彩色化显示,研制出稀土离子掺杂的各色交流电致发光薄膜。研究不同稀土离子在薄膜中的浓度猝灭,以便提高薄膜的发光亮度。在致力于实现彩色的过程中,首要的任务是提高蓝色电致发光薄膜的亮度和探索新的蓝色电致发光薄膜材料:从ZnS:TmF₃到CaS:TmF₃,发光亮度有了很大的提高;使SrS:Ce薄膜蓝色电致发光的亮度超过1000cd/m²;同时探索纳米Si和非晶Si/SiO₂超晶格结构的蓝色电致发光。成功地实现了ZnS:Mn/SrS:Ce白色电致发光和SrS:HoF₃三基色线谱发射的白色电致发光,发光亮度也超过1000cd/m²。     

时变线性系统特征根判稳的推广

本文研究了二维时变线性系统零解的稳定性，给出了一些允许系数矩阵主对角元变号，系数矩阵特征根变号的判定稳定性的充分条件。     

U：CaF2晶体的分凝特性与光谱性质

应用TGT法生长了直径为75mm的U：CaF2晶体，宏观上透明完整.应用公式K0=Cs/Cl计算了U在CaF2晶体中的分凝系数等于0.53.应用溶质分布一般公式Cs=K0C0(1-g)K0-1，计算U的浓度分布与测量值，数值符合说明晶体生长过程接近平衡状态.分析不同条件下生长的U: CaF2晶体的晶胞参数和吸收光谱，结果表明生长气氛决定U的价态及电荷补偿机理：无PbF2存在的条件下，U为+4价，晶体呈绿色；PbF2的加入起到氟化去氧作用，U倾向于以离子半径最接近于Ca2+的U3+存在，晶体呈红色.从晶体生长开始到结束的部位，U3+:CaF2晶体吸收光谱的峰位不变，峰强呈现与U浓度相同的增加趋势.U3+:CaF2晶体外层厚约5mm处呈黄色，含有U3+和U2+的混合价态离子，其原理是石墨坩埚的还原作用通过单质铅，使部分的U3+进一步还原成了U2+. 关键词： 铀 氟化钙晶体 分凝系数 晶胞参数     

The semi‐iterative method applied to the hyper‐power iteration

The semi‐iterative method (SIM) is applied to the hyper‐power (HP) iteration, and necessary and sufficient conditions are given for the convergence of the semi‐iterative–hyper‐power (SIM–HP) iteration. The root convergence rate is computed for both the HP and SIM–HP methods, and the quotient convergence rate is given for the HP iteration. Copyright © 2005 John Wiley & Sons, Ltd.     

组合DEA方法与成熟度模型对项目效益的评价

为全面考虑资金、管理决策能力等因素对项目效益的影响，本运用数据包络分析与项目成熟度模型结合的方法来对企业各个项目之间的相对效益进行评价，应用结果表明该评价方法对于企业资源的最优配置、提高总体效益是十分有用的。     

上市公司资本成本面板数据模型与实证分析

本文利用我国上市公司1997至2002年的有关财务数据,建立了我国上市公司资本成本面板数据模型,运用该模型分析了我国上市公司资本成本与财务杠杆、企业规模的关系.结果表明,财务杠杆的提升、企业规模的扩大将使资本成本下降.该结论对我国上市公司优化资本结构、提高企业价值具有一定的参考价值.     

Determination of the arc-root position in a DC plasma torch

The behavior of an arc operated in the nontransferred mode with a conical-shaped cathode and a nozzle-shaped anode is studied by applying general tyro-dimensional conservation equations and auxiliary relations for the simulation of arc channel flows. The position of the arc-root attachment at the anode surface is determined by using Steenbeck's minimum principle, which postulates a minimum arc voltage for a given current and certain given boundary conditions. The overall effects of the anode-arc root on the plasma flow are, studied by comparing the results with those of the transferred mode of operation. Specific arc-channel diameters are chosen in the simulation in order to verify flit, numerical model through comparisons with experimental results. The results show that Steenbeck's minimum principle is useful for determining the position of the arc-root attachment at the anode surface. Application of this method for control of the arc-anode attachment may be valuable in the design and operation of plasma spray torches to avoid jet instabilities.